kleenoil.ca - Kleenoil Filtration System

Passenger Vehicle Applications

Super Duty Truck Mustang

The cleanliness of your engine fluid is crucial to the trouble-free and cost-effective operation of your engine system. Engine components are costly and need special consideration when this fluid is selected and subsequently filtered.

As soon as you start your engine, the deterioration process of your oil begins. As the engine runs, dirt, wear metal particles, fuel, soot, and water start to weaken your oils lubrication and protection properties. These harmful elements can be eliminated by an oil drain, but once the oil is replaced, the deterioration process just starts over again.

Regular oil drains and filter changes are required to protect our engines and hydraulic systems. The Kleenoil Filtration System, however, allows us to extend the time between oil drains as well as to reduce the adverse effects of harmful particles in the engine.

Normal full-flow filters on your car or truck have approximately 85 to 120 L of oil passing through the filter each minute. As a result, the fluid passes through so quickly that it cannot be finely filtered, nor can water be removed. While the film of oil between moving parts in an engine is generally about 3 micron, regular oil filters only filter down to between 15 and 40 micron.

The Kleenoil Filtration System, however, is a bypass filter that passes only a small portion of the total oil flow a very dense filtering medium at about 2.5 L per minute. At this speed, it is possible to remove particles down to 1 micron and to totally remove water, greatly decreasing engine wear and prolonging oil life.

Key Benefits to Passenger Vehicle Owners

Recommendations for Use

The Kleenoil Filtration System will be a valuable addition for a passenger vehicle if:

For people looking to install the Kleenoil Filtration System on passenger vehicles with smaller oil systems, there should be a few considerations:


Installation and Maintenance Schedule for Passenger Vehicles with Kleenoil Systems


Seeing is believing! Listed below are some oil analysis reports from passenger vehicles:

Wearcheck Oil Analysis - 1999 Ford F-350 7.3L Powerstroke Diesel


Kleenoil Filtration Unit Specifications Table
Kleenoil Recommends the Kleenoil Light Duty Filtration Unit for Passenger Cars / Trucks
  Unit Cartridge
Code Number KU16 KF16
Engine Sump Capacity Up to 16 Litres
Water Retention <0.05% .26 Litres
Height 16.83 cm 10.16 cm
Diameter 11.75 cm 10.48 cm
Type of Usage Smaller Engines, Small Hydraulic Systems
Pressures Maximum rating of 10 bar. Lid torque is 15ft lbs.
Oil Flow Rate Output levels are dependent on the viscosity, temperature, and degree of contamination and oil pressure. (Guide for SAE 15W40 oil at 158 degrees F and 60psi, the flow rate would be 0.55 gpm to 0.81 gpm)
Operating Temperatures Within operating specifications of engine, gear, and hydraulic oils.
Filtration Level Particulate contamination in accordance with BS 5540 part 4: 1981 and ISO/DIS 4406. ISO 14/9 equivalent to NAS 1638 class 6 - hydraulic oil specification.
Castings Constructed of aluminum to BS 1490 (M) Subjected to batch and individual testing.